Aftercare

• Room temperature must be maintained at 20c or above for the full cure time of 24 hours, If the room temp is below this we recommend leaving to cure for an additional 24 hours.

 

• Clean your bath with a soft non-abrasive sponge with warm soapy water, such as diluted fairy liquid or one of the tested eco-cleaners the technician recommends.

 

• If you are in a high limescale area you can add a small amount of white vinegar to your washing up liquid mix.

 

• In high limescale areas or on baths with low spots , you should dry the bath after use to prevent damage caused by standing water and limescale.

 

• Avoid products with high colour concentration such as bubble baths, bath bombs, iodine treatments such as betadine shampoo, and home hair dyes and colourants, as these can cause staining.

 

• Should you chip the surface of your bath, please contact us for advice.

 

• The use of bath mats /pillows and toys with suction pads are not advisable. If used, wait at least four weeks before use and always remove immediately after each use to allow the surface of the bath to dry properly.

 

• Should minor staining occur on your bath, it can sometimes be removed with a car polish and a microfibre cloth.